Installation

SPEAKMAN
®
400 Anchor Mill Rd. New Castle, DE 19720 Phone: [phone] Fax: [phone]
11/03/17 www.speakman.com 92-SE-565-01
SPEAKMAN
®
SE-565
Installation, Operation & Maintenance Instructions
EYESAVER® EYEWASH
DESCRIPTION
Deck mounted emergency eyewash. Supplied with stainless steel bowl, stay-open full flow ball valve;
activated by stainless steel trigger bar; adjustable volume regulator, aerated spray outlets with individual
adjustments for maximum performance, and mounted on counter tops up to 2” thick.
SPECIFICATIONS
BOWL: 300 SERIES STAINLESS STEEL
SPRAY HEADS: (2) BRASS, CHROME-PLATED, AERATED
VALVE: 1/2” NPT FEMALE BRASS, CHROME-PLATED
ACTIVATOR: STAINLESS STEEL TRIGGER BAR
INLET: 1/2” NPT FEMALE
SHIPPING WEIGHT: 7.1 LBS
EMERGENCY SIGN: 7-7/8” X 7-7/8” PLASTIC WALL SIGN
Options:
PT
P-Trap
SSBV2
1/2” Stainless Steel Valve
ILS
In-Line Strainer
HS
SE-920 Hand Held Drench Hose
FPV
Anti-Freeze Protection Valve
HFO
Hand/Foot Operation
SPV
Anti-Scald Protection Valve
INSTALLATION
NOTE: This unit should be connected to an uninterrupted
source of potable water, with a minimum flowing pressure
of 30 PSI and a maximum static pressure of 125 PSI.
Use cutting/drilling instruction template (supplied) to cut and drill holes in desired location on countertop.
Once bowl is mounted securely to countertop using mounting hardware supplied, complete assembly of ball
valve and push handle. Review drawing (as shown on other side) to assure proper installation. Be sure to
apply a bead of waterproof caulk along edge of bowl and countertop to prevent water draining under
countertop. Connect a water supply to the unit (use pipe sealant on all joints) that is a 1/2” minimum
uninterrupted source of potable water. Failure to use potable water can result in emergency units producing
impure or contaminated water causing possible further injury. The drain tailpiece or waste should be
connected to an adequate drain in compliance with local plumbing codes. This unit is supplied with a volume
control that can control the amount of water delivered, even at higher pressures. This should be set after unit
is completely installed so that streams from spray outlets converge in the middle of the eyewash bowl.
OPERATION
The eyewash is activated by pushing the trigger bar back 90°. Once the unit is activated, water will discharge
from the spray outlets until the trigger bar is manually pulled back to the off position.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be
activated on a weekly basis to flush the line and verify proper operation. Speakman Company furnishes a
testing record tag (91-0635) with each unit. On this tag the date of inspection and the inspectors initials
should be noted.