Installation

①RPG04-0432-(PC,BN)
③RPG45-0048
④RPG24-0127-(PC,BN)
②RPG20-2053
Unscrew the nut (1) from the pop-up body.
Note: retain the seal (2) on the horizontal rod
(3). Place the nut onto the horizontal rod and
insert the rod and seal (2) into the pivot hole
(4). Install stopper (5) as non-removable (6).
Slide nut (1) on and hand tighten only.
Tighten nut (1) clockwise until the pop-up drain
assembly is secure.
Place one end of spring clip (1) on the end of
horizontal rod (2). Insert rod through hole in
lift rod strap (3). Secure with spring clip (1).
Insert lift rod (1) into strap (2) and tighten
screw (3).
After installation is completed, remove aerator
with wrench. Turn on water supply and allow
both hot and cold water to run for at least one
minute each. While water is running, check for
leaks. Replace aerator
⑥
⑦
⑧
⑨
4
5
6
2
3
1
1
2
3
1
IMPORTANT:
③
④
⑩
2
3
1
①
②
5.94''
[151.00mm]
1/2"-14NPSM-2A
2.32''
[59.00mm]
6.67''
[169.37mm]
6.66''
[169.25mm]
4.85''
[123.10mm]
3.57''
[90.76mm]
MAX 2.39''
[60.68mm]