Installation
RPG04-0415 (-BN)
1
RPG05-0959
2
RPG05-0960
3
RPG45-0057
4
RPG05-0915 (1.5GPM)
5
RPG63-0089
6
Insert lift rod (1) into strap (2) and tighten screw(3).
6
7 10
9
8 11
After installation is completed, remove aerator.
Turn on water supply and allow both hot and
cold water to run for at least one minute each to remove
the debris. While water is running ,check for leaks.
Replace aerator.
IMPORTANT:
1
2
3
1
2
/
3
4
2X
6
5
14.29”
[363mm]
2.21”
[56mm]
3.14”
[80mm]
8.03”
[204mm]
4.02”
[102mm]
1.18”
[30mm]
4.76”
[121mm]
6.70”
[170mm]
2.79”
[71mm]
10°
Place the rubber washer (2) to underside of the
flange (1). Insert the threaded end of the drain
body up through the drain hole and attach flange to
the body with the pivot hole (3) pointing to the rear
of the sink.
1
3
2
Unscrew the nut (1) from the pop-up body .
NOTE:Retain the seal (2) on the pivot rod (3) .
Place the nut onto the pivot rod insert the rod and
seal (2) into the pivot hole (4) .Install stopper (5) as
shown (6) .Slide nut (1) on and hand tighten.
(Please do not overtighten).
1
2
4
3
5
6
Tighten lock nut (1) by rotating counterclockwise
until the pop-up drain assembly is secure.
Rubber washer should be on top of sink.
1
Place one end of spring clip (1) on the end of
pivot rod (2) . Insert rod through hole in
lift rod strap (3) .Secure with spring clip (1) .
1
3
2
7
RPG05-40126 (1.2GPM)
7