Installation

8
From beneath, secure Rubber Washer ❶, by
hand-tightening Nut ❷ as shown below. Place
Stopper ❸ into drain with the engagement tab at
rear as shown below.
Align
towards
faucet.
9
Remove Pivot Nut ❶, from Drain Assembly.
Install Pivot Rod ❷, and ensure that Inner Pivot
Washer ❸ is retained in Drain Assembly. Insert
Pivot Rod into Drain Assembly and install Stopper
❹ as non-removable. Secure Pivot Rod to Drain
Assembly by tightening Pivot Nut ❶.
10
Place one end of Spring Clip ❶, on Pivot Rod
❷. Insert Pivot Rod ❷ through a hole in the Lift
Rod Strap ❸. Secure with Spring Clip ❶. Insert
Lift Rod into Strap and secure with Nut ❹. Make
remaining plumbing connections to your drain
system.
11
IMPORTANT: After drain installation is completed, remove Aerator if installed, using supplied Aerator
Wrench. Turn on water supply and allow both hot and cold water to run for at least one minute each. While water
is running, check for leaks. Return the HOT and COLD handles to the "OFF" position. Replace Aerator.