Installation

S-5122 REPAIR PARTS
SPEAKMAN
®
RPG05-108759 METERING VALVE
RPG05-109171 AERATOR
RPG05-108765 MOUNTING HARDWARE
RPG05-108060 HANDLE INDICATORS
ITEM NO. PART NO. DESCRIPTION
S-5122 ROUGH-IN DIAGRAM
SPEAKMAN
®
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
4
1
4
"
108mm
1
15
16
"
49mm
3
15
16
"
100mm
1
3
8
"
34mm
1
1
2
"
39mm
1
15
16
"
49mm
5
7
16
"
138mm
1/2"-14 NPSM THD
1"
25mm
MAX DECK THICKNESS
2"
51mm
13
16
"
21mm
MIN DECK HOLE
2"
MIN. TO LEDGE
51mm
2"
MIN. TO WALL
51mm
LAVATORY ROUGH-IN
21mm
13
16
"
NOTES:
COMPLIANCE:
CONNECTIONS:
ASME A112.18.1/CSA B 125.1
FLOW DATA:
0.25gpc (0.95 L/cycle)
Supply Connection:
1/2"-14 NPSM Connection
Contractor to supply necessary inlet
connections.
TIMING ADJUSTMENT 1
The spray timing is pre-adjusted at the factory. However, due to different field conditions, this adjustment may need to
be modified at the time of installation. Begin by removing the Screw (1) from the back side of the Faucet using the
supplied Hex Wrench. Lift the Handle Assembly (2) to remove and place aside.
Remove the Cartridge Cap (3) and place aside.
TIMING ADJUSTMENT 2
Using a Flat Tip Screwdriver, either thread in or out the end screw of the metering cartridge to adjust the duration of the
spray timing. IMPORTANT: Do NOT screw more than 1 complete rotation in either direction or damage may occur.
Replace the Cartidge Cap and Handle Assembly and press down on the handle to test spray duration. Once proper
timing is achieved replace the Screw to the back of the faucet and tighten.
¼ CLOCKWISE = INCREASE RUN TIME
¼ COUNTER CLOCKWISE = DECREASE RUN TIME