Installation Instructions

Install Wall Bracket using Supplied Screws.
Mounting location is optional. In drywall or tile
applications, be sure to use appropriate
hardware.
Retrieve the Showerhead. Thread onto the
Gooseneck and wrench tighten.
Note: Showerhead may differ from illustration.
7
8
ROUGH-IN DIAGRAM
Notes:
1. Dimensions shown are for S-2252 Showerhead.
2. Dimensions are subject to change without notice.
3. Unit can be also be installed in a ceiling or floor supply.
10
The Handle and Dial Cap must be removed to
adjust the Temperature Limit Stop. Remove the
Handle Screw (1), then slide the Handle (2) off.
Remove the Dial Cap Screw (3) followed by
sliding off the Dial Cap.
9
2
1
3
4
1
2
3
4
5
O-RING
7
1
2
"
190.5mm
S-2252
Pipe Strap
W/ Screws
(Location
Optional)
Loose Key
Angle Stop
(2 Places)
Cold Inlet
Union
5"
127mm
6"
152.24mm
7
1
4
184.29mm
18
7
8
"
479.59mm
4'-6"
(1.37 meters)
To Floor
"
Hot Inlet
Union
1"
25.4mm