Installation & Assembly

22 SENSOR FAUCET BATTERY POWER
Install the Battery Box Cover (1) and reconnect the GREEN Connector (2). Make sure the cover is fully pressed in.
22
23 SENSOR FAUCET BATTERY POWER
Insert the Battery Box (1) into the Faucet Body and install the Faucet Lid (2).
23
FAUCET BATTERY POWER
24 FAUCET BATTERY POWER
Fasten the 2 Vandal Resistant Screws (1). Make sure there are no gaps between the Lid and the Faucet Body.
25 SOAP DISPENSER BATTERY POWER
• Access the interior Battery Enclosure by unscrewing the two (X2) Screws using a Phillips Screwdriver (1).
• Insert or replace the batteries with four (X4) new standard 1.5v D size batteries. Ensure the position of the
new batteries are aligned to the plus (+) and minus (-) symbols within the battery holder (2).
BATTERIES NOT INCLUDED
26 SOAP DISPENSER BATTERY POWER
• Close the Battery Box by tightening the two (X2) Philips screws. Determine the desired location of the Battery
Box, make sure the Connecting Wire is long enough to reach the Control Box. Mount the Control Box onto the
previously marked location using a Phillips Screwdriver and two (X2) Mounting screws (included) (1). If
mounting on drywall and not to stud, use the appropriate anchors and fasteners for application. Recommend
screw in EZ anchor or equal for drywall.
• Connect the Blue Battery Connector to the Blue Male Connector on the side of the Control Box (2).
45" MAX
WIRE LENGTH
BLUE
27 A/C POWER ELECTRICAL CONNECTIONS
• Verify that no batteries are present within the battery
enclosures. Connect one male end of the "Y" Power
Cable to the sensor wire on the faucet (1).
• Connect the remaining male plug on the "Y" Power
Cable to the control box of the soap dispenser (2).
• Connect the A/C adaptor to the black female port
on the "Y" Power Cable (3). Plug the AC adaptor into
the wall outlet.
BLACK
28
Turn on water supplies and check for leaks.
Activate Sensor and allow Faucet to run for 1
minute to flush out any debris.
29
Install Aerator. Tighten with included Aerator
Wrench.
FAUCET AERATOR INSTALL
30 PRIMING THE SOAP DISPENSER
For first time use, or after soap refill,
activate the Sensor Soap Dispenser
repeatedly to prime the pump. It may take
approximately 10-30 activations
(depending on tube length) to get the pump
primed. Check to make sure that there are
no leaks.
10-30
ACTIVATIONS
VIEW FROM UNDERNEATH
SENSOR EYE