Installation & Assembly

11
Align the SOAP and AIR tubes to the Control
Box. Cut to length and press tubing over barbed
fittings on Control Box.
AIR
SOAP
WARNING: Running excessive tubing may lead to decrease
in performance. Always keep tube length to minimum.
SOAP DISPENSER INSTALLATION
12
Open the Soap Bottle Lid by pulling the
C Clip away.
13
Lift the Cap to access soap bottle.
14
Pour Soap into the Soap Container. This Soap
Dispenser will work with both Liquid Hand Soap
and Foaming Hand Soap with a viscosity
of < 1000cP.
LIQUID
OR
FOAM
FILL/REFILLING SOAP
15
• After filling the soap bottle, align the cutout of
the cap and close the bottle cap. Make sure the
feed tube reaches all the way to the bottom of the
bottle.
• Secure the Cap with the C Clip.
16
• Align the UNLOCK Symbol of the Soap Bottle to the Vertical Line on the Control Box.
• Press upwards for engagement and rotate clockwise until the LOCK symbol of the Soap Bottle is aligned to
the vertical line on the Control Box.
17
Select the proper Mode of the Sensor Soap
Dispenser based on the soap filled. The Mode
Switch button is located on the left side of the
Control Box.
FOAMFOAM
SOAPSOAP
LIQUIDLIQUID
SOAPSOAP
FILL/REFILLING SOAP
18 SOAP DISPENSER SENSOR CONNECTIONS
Make electrical connections from the Sensor Eye to the Control Box. Connect the Blue Male Ended Wire to the
Blue Female Connection. Connect the Green Male Ended Wire to the Green Female Connection. To further aid
proper alignment, there are white alignment lines on the connector ends. These alignment lines should face
forward when properly installed.
GREEN
BLUE
If using
Battery Power
please continue to
STEP 19.
If using
AC power,
please skip to
STEP 27.
19 FAUCET BATTERY
POWER
Use the provided Torx Bit tool to release the two
(2) Screws (1) and slide up to open the Lid (2) .
NOTE:
Be sure to cover your drain.
Disconnect the GREEN Connector (1) and pull out the Battery Box (2).
20
21 FAUCET BATTERY POWER
Push to release the Battery Box Cover (1). Insert or replace the batteries with six (6) new standard 1.5v AA
batteries (2). Ensure the position of the new batteries are aligned to the plus (+) and minus (-) symbols within
the battery holder.
21
FAUCET BATTERY POWER