Installation Guide

OPERATION
Note- The sink fitting does not have to be turned on for the eyewash to operate.
Eyewash- The eyewash is activated by squeezing the handle until it locks into the ON position. Water
will discharge from the twin spray outlets, and continue to flow until the handle is squeezed again, the
stay-open plunger is pulled and held while the handle is released.
The flow of the individual spray heads is controlled by built-in flow controls. Each spray assembly is
tested for flow and alignment in the factory.
TESTING PROGRAM
ANSI Z358.1 requires that all emergency equipment shall be tested weekly to verify proper operation
and inspected annually to assure conformance with ANSI Z358.1 - 1998 requirement.
MAINTENANCE (CARE and CLEANING)
The eyewash valve has a rubber seat washer, which may require periodical maintenance. The
eyewash unit can be cleaned by using mild soap and warm water. Rinse thoroughly and dry
immediately with a soft, clean cloth for best results.
REPAIR PARTS LISTING
Part or
Group Number
Description
Refer to Packing
List Figure
RPG38-0390 Yellow spray head assembly Part of item 1
RPG45-0033 Rubber seat washer and screw Part of item 1
Page 4 of 4
11/02
92-2161
PO BOX 191 Wilmington, DE 19899
Phone [phone] Fax [phone]
www.speakmancompany.com
SPEAKMAN
®