Installation Sheet

Connect one end of the remaining hose to the blank port of the

supply tee with no check valves. Connect the remaining end to the

3/8” port of the COLD end body. Wrench tighten.

Turn on water supplies and check for leaks. Activate Eyewash by

lifting activation handle and check for proper function using the

chart at the the end of this document. Tepid water supply should

be between 65°-95° F. Check the SE-370 manual for temperature

adjustment instructions.

NOTE: Before testing, you must remove tape from Eyewash Caps.

Slide trim sleeve (1) over the spindle, followed by the handle (2),

lock washer (3) and screw (4). Tighten screw and install colored

index (5). RED=HOT, BLUE=COLD. Repeat for other side.

The handle trim can now be installed. Place flange (1) over spindle

and lower onto end body. Thread collar (2) onto end body and hand

tighten. Repeat for other side.