Installation Sheet

From beneath countertop, slide the rubber mounting washer (1), then

brass mounting washer (2) over the mounting studs. Thread brass

nuts (3) onto mounting studs. Align spout square to sink and tighten

mounting nuts (3).

Locate end body with a red marking. From below, position the red

(HOT) end body up through the corresponding hole location in the

countertop and loosely secure with rubber washer (1) and end body

flange nut (2). Repeat process for the blue (COLD) end body.

While holding the end body from below, tighten end body flange

nut until the top is flush with the start of the chamfer (see below).

Tighten the set screw (1) to secure this position. Repeat for the blue

(COLD) end body.

The end bodies are installed next. First, the end body flange nuts (1)

and rubber washers (2) must be removed. At the same time, loosen

the mounting nut (3) to lower the cup washer. Repeat process for the

blue (COLD) end body.

X2 X2