Installation Guide

Turn on water supplies and check for leaks. Activate Eyewash by
lifting activation handle and check for proper function using the
chart at the the end of this document.
Slide trim sleeve (1) over the spindle, followed by the handle (2),
lock washer (3) and screw (4). Tighten screw and install colored
index (5). RED=HOT, BLUE=COLD. Repeat for other side.
19
20
5
X2
4
3
2
1
The spout was designed to swivel from left to right. If a
non-swivel spout is preferred, remove top cover from body.
Remove allen head set screw from position (1) as seen below.
Center the spout between the handles and install the previously
removed set screw into position (2) and tighten (DO NOT
OVERTIGHTEN). Replace cap.
Turn on HOT and COLD handles of faucet and allow water to run for
one minute to flush any debris from faucet. Install the aerator with
the supplied aerator wrench.
21
22
2
1
NOTE: Before testing, you must remove tape from Eyewash Caps.