Installation Guide

Retrieve the two (2) remaining supplied hoses. Take the first hose and

connect one end to the “E” port of the supply tee with no check

valves. Connect the remaining end to the 3/8” port of the HOT

end body. Wrench tighten.

Retrieve the supply tee with no check valves. Connect the “F” port of

the supply tee to the remaining hose pre-installed in the base of the

SEF-1801. Wrench tighten.

The handle trim can now be installed. Place flange (1) over spindle

and lower onto end body. Thread collar (2) onto end body and hand

tighten. Repeat for other side.

Connect one end of the remaining hose to the blank port of the

supply tee with no check valves. Connect the remaining end to the

3/8” port of the COLD end body. Wrench tighten.