Installation Guide

Locate the supply tee with check valves installed. Connect remaining
end of hose to the port with no markings. Wrench tighten.
Locate the hose labeled “EYEWASH” that is pre-installed in the base of
the SEF-1801. Connect this hose to the “E” port of the tee with check
valves. Wrench tighten.
Tighten the lower nut (1) to secure the end body to the sink. Be sure
to keep the end body outlet oriented towards the spout. Repeat for
the other end body.
7
8
9
10
Retrieve the 6” long hose with a BLUE stripe from the box and connect
one end to the COLD supply valve. Wrench tighten.
COLD
1
X2