Installation Guide

From beneath countertop, slide the rubber mounting washer (1), then

brass mounting washer (2) over the mounting studs. Thread brass

nuts (3) onto mounting studs. Align spout square to sink and tighten

mounting nuts (3).

From below the counter top, push the end body through the outer

hole in the sink. Repeat for the other end body.

While holding the end body from below, replace the rubber washer

followed by the flange nut and tighten until the top is flush with the

start of the chamfer (see below). Tighten the set screw (1) to secure

this position. Repeat for the other end body.

The end bodies are installed next. First, the end body flange nuts (1)

and rubber washers (2) must be removed. At the same time, loosen

the mounting nut (3) to lower the cup washer. Repeat for the other

end body.

X2 X2