Installation Guide

SPEAKMAN COMPANY
SE-911-SS Installation, Maintenance & Operation Instructions
DESCRIPTION
Stay-Open ball valve for emergency showers.
SPECIFICATIONS
VALVE: 1” NPT Female Stainless Steel. Stay-Open Ball Valve.
INLET: 1” NPT Female.
OUTLET: 1” NPT Female.
SHIPPING WEIGHT: 3 lb.
SE-911-CR-SS
SE-911-SS With 8” and 3” S/S Rings on #3 S/S Chains.
SHIPPING WEIGHT: 3 lb.
SE-911-PR-SS
SE-911-SS With Powder Coated Yellow, AluminumTriangular Pull Rod.
SHIPPING WEIGHT: 6 lb.
OPTIONS
INSTALLATION
Assemble valve to a horizontal or vertical water supply that has an uninterrupted source of potable water. Use pipe
sealant on all joints. Failure to use potable water can result in emergency units producing impure or contaminated
water causing possible further injury.
OPERATION
This valve is activated one of two ways, depending on the model in question.
1. SE-911-PR-SS: Valve is activated by pulling downward on the aluminum pull rod, and is deactivated by
manually pushing the pull rod back to the off position.
2. SE-911-CR-SS: Valve is activated by pulling downward on the 8” dia. stainless steel ring, and is deactivated
by pulling downward on the 3” dia. stainless steel ring.
Both model valves will discharge water until they are manually shut off following the instructions above.
TESTING PROGRAM
The American National Standards Institute (ANSI) states that all safety emergency equipment shall be activated on
a weekly basis to flush the line and verify proper operation. Speakman Company furnishes a testing record tag
(91-0635) with each unit. On this tag the date of inspection and the inspectors initials should be noted.
◊ SSBV1
(1” Stainless Steel Valve)