Installation Guide

INSTALLATION INSTRUCTIONS
SECURING UNITS
1. SE-7000 is equipped with a cast floor flange. Suitable anchors must be used to ensure that the unit is
rigid and properly secured before being used.
NOTE: If desired or required, additional straps or braces can be used to secure any
unit. (BE SURE NOT TO DRILL OR SCREW ANYTHING INTO THE OUTER PLASTIC
SHELL.)
PLUMBING CONNECTION
1. The installer has the responsibility to see that the unit is connected to a potable water supply, with a
temperature that would allow the user to shower for a minimum of 15 minutes without discomfort or
shock due to cold water temperature. (ANSI Z358.1 recommends that water temperature be between
60°-90° F.)
2. Inlet connection is 1" pipe. Supply line should have a suitable pressure to deliver a minimum flow of
30 GPM to the shower head.
3. Attach eye/face wash to lower arm by threading assembly into encased tee. Be sure to use a thread
sealant to guard against leaks. Fasten push handle to spindle extension on lower arm. Screw is
located in extension.