Installation Guide

From above the sink, place decorative flange ,
then screw escutcheon onto end body valve
assemblies and hand tighten. Slip trim sleeves
onto spindles. Position handles , lock washers
and use screws to secure to spindles. Position
index buttons on handles (blue on right
handle, red on left handle) and press into place.
LAVATORY ROUGH IN
1
1
2
"
38mm
1
3
8
"
35mm
2"
51mm
MIN. TO WALL
2"
51mm
MIN. TO LEDGE
Turn on water supplies and flush both HOT and
COLD cartridges for one minute, while checking
for leaks. Once completed, install aerator into
spout end using supplied aerator wrench.
REPAIR PART GROUPS
ITEM PART NUMBER DESCRIPTION
1 RPG20-2011-CA END BODY ASSEMBLY (RED) W/ MOUNTING HARDWARE & HOSE ADAPTER
2 RPG20-2012-CA END BODY ASSEMBLY (BLUE) W/ MOUNTING HARDWARE & HOSE ADAPTER
3 RPG05-0534-CA PERFECT VALVE GROUP (RED) WITH TRIM SLEEVE & SCREW
4 RPG05-0535-CA PERFECT VALVE GROUP (BLUE) WITH TRIM SLEEVE & SCREW
5 RPG10-0070-PC TRIM COLLAR & FLANGE GROUP
6 RPG04-0320-PC METAL LEVER HANDLE GROUP
7 RPG04-0316-PC 4" WRIST BLADE HANDLE GROUP
8 RPG41-0285 RED,BLUE, & CHROME INDEXES WITH SCREWS & LOCK WASHERS
9 G18-0251-CA CENTER SPOUT ASSEMBLY (LESS LIFT ROD HOLE)
10
11
12
RPG05-0837-PC 1.5 GPM (5.7 L/min) AERATOR ASSEMBLY WITH WRENCH
RPG38-0128-PC BOCA FLOW OUTLET ASSEMBLY WITH WRENCH
RPG05-0851-PC 1.5 GPM (5.7 L/min) LAMINAR FLOW OUTLET ASSEMBLY WITH WRENCH
13
RPG05-40005 1.2 GPM (4.5 L/min) AERATOR ASSEMBLY WITH WRENCH
1.2 GPM (4.5 L/min) LAMINAR FLOW OUTLET ASSEMBLY WITH WRENCH14 RPG05-40015
⑬
⑭