Installation Guide

11
From above the sink, place decorative Flange
(1), then screw Escutcheon (2) onto end body
valve assemblies and hand tighten. Slip Trim
Sleeves (3) onto spindles. Position Handles (4),
Lock Washers (5) (SC-3004 series) and use
Screws (6) to secure to spindles. Position Index
Buttons (7) on handles (blue on right handle, red
on left handle) and press into place.
SC-3004
SERIES
12
Assemble gooseneck to flange assembly by
wrench tightening Gooseneck Collar Nut (1).
NOTE: For rigid gooseneck, place Locking
Washer (2) from hardware bag group into flange
outlet before assembling gooseneck.
13
Turn on water supplies and flush both HOT and
COLD cartridges for one minute, while checking
for leaks. Once completed, install aerator into
spout end using supplied aerator wrench.
NOTE: If installing SC-3004-FC-LD, this model does not
use an aerator.
LAVATORY ROUGH IN
1
1
2
"
38mm
1
3
8
"
35mm
2"
51mm
MIN. TO WALL
2"
51mm
MIN. TO LEDGE
SC-300X-LD REPAIR PARTS
SPEAKMAN
®
RPG20-2011-CA END BODY ASSEMBLY (RED) W/ MOUNTING HARDWARE & HOSE ADAPTER
RPG20-2012-CA END BODY ASSEMBLY (BLUE) W/ MOUNTING HARDWARE & HOSE ADAPTER
RPG05-0534-CA PERFECT VALVE GROUP (RED) WITH TRIM SLEEVE & SCREW
RPG05-0535-CA PERFECT VALVE GROUP (BLUE) WITH TRIM SLEEVE & SCREW
RPG10-0070-PC TRIM COLLAR & FLANGE GROUP
RPG04-0320-PC METAL LEVER HANDLE GROUP
RPG04-0316-PC 4" WRIST BLADE HANDLE GROUP
RPG41-0285 RED,BLUE, & CHROME INDEXES WITH SCREWS & LOCK WASHERS
G18-0217-CA 8" GOOSENECK ASSEMBLY (INCLUDING O-RING)
RPG18-0213-CA 5" GOOSENECK ASSEMBLY (INCLUDING O-RING)
G18-0212-CA 5" FC GOOSENECK ASSEMBLY (INCLUDING O-RING)
RPG05-0837-PC 1.5 GPM (5.7 L/min) AERATOR ASSEMBLY WITH WRENCH
RPG38-0128-PC BOCA 0.5 GPM FLOW OUTLET ASSEMBLY WITH WRENCH (-E)
RPG05-0851-PC 1.5 GPM (5.7 L/min) LAMINAR FLOW OUTLET ASSEMBLY WITH WRENCH
A-EA12 1.2 GPM (4.5 L/min) AERATOR ASSEMBLY WITH WRENCH
A-ELF 1.2 GPM (4.5 L/min) LAMINAR FLOW OUTLET ASSEMBLY WITH WRENCH
ITEM NO. PART NO. DESCRIPTION