Instructions / Assembly

Bench assemble the Tee to the HOT and COLD
end body valves. Be sure to fully seat the copper
piping into the end body valves, and hand
tighten Compression Nuts to the outlet ports.
Be sure the end body valves are perpendicular
to the Tee assembly.
90°
Insert and position the gooseneck flange with
gasket down through the center hole of the
sink or counter top, being sure the cut out of the
gasket is aligned to the rear of the faucet. Assemble
Rubber Washer , Metal Channel Washer and
Mounting Nut to shank and thread only half way
up the shank.
Loosen the set screws and remove the end
body valve flange nuts and rubber washers
Screw the locknuts and cup washers
down on end body valves.
From below the counter top, push the end body
with tee assembly up through the outer holes in
the sink or counter top. NOTE: Blue colored
end body (COLD) should be on the right side
of tee assembly, Red colored end body (HOT)
on the left. Hand tighten the tee assembly’s
swivel nut to the shank of the gooseneck
flange .
BLUE
(COLD)
RED
(HOT)
While lifting the end body with tee assembly
up by its spindles, replace the rubber washers
and screw the flange nuts back onto the end
body valves, with flat side up, till they are flush
with the tops of the 1-1/8”-16 UN threads of
the end body valves.
NOTE: Do Not Overtighten Swivel Nut
From below, wrench tighten the gooseneck
flange nut with channel washer/spacer ,
tee swivel nut , end body valve locknuts
with cup washers , and two (2) tee
compression nuts at the outlets of the end
body valves to secure the entire unit and
prevent leaks.
Ensure the Flange Nuts are flush with the tops
of the 1-1/8”-16 UN threads, then tighten set
screws .
Connect water supply lines to inlets (1/2”-14
NPSM male threads) of the end body valves
and wrench tighten coupling nuts to prevent
leaks.
NOTE: Flex Hoses and Shut Off Valves not included.
1/2”-14 NPSM