Installation Guide

ManualsBrandsSpeakman ManualsBathLura 2-Handle Wall Mount Bathroom Faucet with Lever Handles in Brushed Bronze

IMPORTANT:

Complete wall construction and finish surfaces before continuing installation.

4 ASSEMBLE HANDLES TO FAUCET BODY

• Loosen but do not remove Set-Screws (1) from flanges of handles using the included Hex Key

and remove Threaded Sleeves (2) from assembly.

• Remove Rough-In Sleeves from faucet.

• Using the Hex Post (1) at the front of one of the rough-in sleeves, assemble the Threaded

Sleeves (2) to the hot and cold handle inlets of the faucet body. Make sure to screw the threaded

sleeves tightly to the front of the mounting wall.

• With the cartridge in the "Off" position, align handle to desired "Off" position, and engage

the splines of the valve into the handle assembly.

• Take the top half of the handle assembly and install onto the threaded sleeves. Make sure there

is engagement between the female spline of the handle assembly and the male spline found

inside the handle inlet.

• Rotate Handle Flange (3) until Set-Screw is facing downward. Tighten Set-Screw (4) using the

included Hex Key to lock flange in place.

• Rotate the handle from the "Off" position to the "On" position and back again. Verify proper

alignment of handle in the "Off" position.

SB-2551

HANDLE ALIGNMENT

SB-2552

HANDLE ALIGNMENT

SB-2553

HANDLE ALIGNMENT

5 ASSEMBLE SPOUT TO FAUCET BODY

• Loosen but do not remove Set-Screw (1) from flange of spout and remove Threaded

Sleeve (2) from assembly using the included Hex Key.

• Using the Hex Post (1) at the front of one of the rough-in sleeves, assemble the Threaded

Sleeve (2) of the spout assembly to the faucet body. Make sure to screw the threaded

sleeve tightly to the front of the mounting wall.

• Take the Spout (3) of the faucet assembly and install onto the threaded sleeve. Make

sure outlet of spout is facing downward.

• Tighten Set-Screw (4) using the included Hex Key to lock spout in place.

Remove Mounting Nut (1), Metal Washer

(2), and Sealing Washer (3) from Drain

Assembly.

Apply included Upper Drain Seal (1) or

Plumber’s Putty to the underside of the

Upper Flange. Insert Drain Assembly into

drain hole of sink from above.

From below, install Sealing Washer (3),

Metal Washer (2), and secure with

Mounting Nut (1). Tighten with Slip Joint

Pliers. Take care to not over-tighten

connection.

Test Drain operation by pressing down on

Stopper to open/close Drain.

DRAIN ASSEMBLY