Installation Guide

ManualsBrandsSpeakman ManualsKitchenLura Single Handle Pull Down Sprayer Kitchen Faucet with Two Function Spray in Brushed Bronze

INSTALLATION INSTRUCTIONS

SB-2542

Pull Down Kitchen Faucet

800-537-2107

www.speakman.com

92-SB-2542-01

NEED HELP?

For additional assistance or service please contact:

Eye

Protection

5 Gallon

Bucket

Adjustable

Wrench

TOOLS & SUPPLIES NEEDED

IMPORTANT

FINISH MAINTENANCE:

Keep the surface finish looking new by cleaning

it periodically with a soft cloth. Avoid abrasive

cleaners, steel wool, and harsh chemicals as

these will dull the finish and void your warranty.

SAFETY TIPS:

Be sure to read and understand all instructions

before beginning installation.

Inspect all connections after installation.

Cover the drain to avoid loss of parts.

Be sure to wear proper eye protection.

Do NOT over tighten any connections or damage

may occur.

Shut OFF water supplies before beginning

installation.

Observe all local plumbing and building codes.

This Faucet has an operating range of 20-80 psi.

CHECK FOR BASE GASKET

Verify that the Rubber Washer is properly

seated into the base of the Faucet.

PLACE INTO POSITION

Place Hoses (one at a time) through the

hole in the mounting surface. Lower

Faucet into position. If installing optional

Deck Plate, place Hoses through the Deck

Plate first.

INSTALL EASY MOUNT NUT

Slide Easy Mount Nut over the Hoses and

upwards over the Threaded Shank until it

makes contact with the mounting surface

(A). Press upward firmly on the Easy

Mount Nut, then rotate by hand to final

tighten into position (B).

NOTE: SUPPLY STOPS NOT INCLUDED

9/16”-24 UNF

3/8” Compression

MAKE CONNECTIONS TO WATER SUPPLIES

Make connections to water supplies. The inlet threads of the Faucet Hoses are 9/16”-24 UNF and

will accept 3/8” Compression connections.

1 Minute

FLUSH SYSTEM

Place Spray Hose (exiting from base of faucet) into a bucket. Turn ON water supplies. Flush both

HOT and COLD water for 1 minute into the bucket.

“CLICK”

CONNECT HOSES

Turn OFF water supplies. Connect the

Spray Hose to the Outlet Hose. Align the

tabs as shown below. This is a “push to

connect” connection. Make sure to push

the connection together tightly and verify

proper connection.

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTIONS SB-2542 Pull Down Kitchen Faucet TOOLS & SUPPLIES NEEDED CHECK FOR BASE GASKET 1 Eye Protection Adjustable Wrench Verify that the Rubber Washer is properly seated into the base of the Faucet. PLACE INTO POSITION 2 5 Gallon Bucket Place Hoses (one at a time) through the hole in the mounting surface. Lower Faucet into position. If installing optional Deck Plate, place Hoses through the Deck Plate first.
PAGE 2
INSTALL WEIGHT TO HOSE 7 TEST FOR PROPER OPERATION Install the Weight Clip onto the Hose at the indicated area (A). Slide the Weight onto the Weight Clip (B). 8 Turn ON water supplies and test for proper operation. Inspect for leaks. B A PLACE WEIGHT HERE REPAIR PARTS ROUGH IN DIAGRAM COMPLIANCE KITCHEN ROUGH-IN ASME A112.18.1 / CSA B125.1 NSF / ANSI 61 NSF / ANSI 372 CEC (California Energy Commission) 2" 51mm MIN.