Installation Guide

• Ensure the Faucet Handles are in the OFF position. Turn ON the Cold and Hot Water Supplies and check for

leaks. If you discover any leaks, check your connections to ensure they are installed properly.

• Remove the Diffusor from the Spout using the Flat Tip Screwdriver. Insert the Flat Tip of Screwdriver into the

gap (farther side) between the Diffusor and the Spout. Pry the Screwdriver outwards for the Diffusor to slide out

of the Spout.

NOTE: There is a slot inside the arch portion of the Diffusor for insertion of the Flat Tip of Screwdriver.

• Turn the Cold Handle and Hot Handle to allow the water to run through the Spout for at least one minute.

• While the Water is running check for any leaks.

• Turn OFF the Cold and Hot Handles and reinstall the Diffusor.

CONFIRM PROPER INSTALLATION

• Point the Coupling end of the Hand Shower Hose (1) into the Bathtub/Drain. Turn ON Hot and Cold Handles,

and rotate the Diverter Handle clockwise to allow the Water to run for at least one minute from the Flexible Hose

into the Bathtub Drain.

• While the Water is running through the Flexible Hose check for any leaks.

• Turn OFF the Cold and Hot Handles and install the Hand Shower Wand to the Hand Shower Hose. Hand

Tighten until a leak free connection is established.

CONFIRM PROPER INSTALLATION

SB-2531 / SB-2533 REPAIR PARTS

SPEAKMAN

RPG05-105440-XX-E15 (XX=FINISH)

HANDHELD REPAIR GROUP

RPG63-113138-XX (XX=FINISH)

HOSE REPAIR GROUP

RPG05-113161

DIVERTER CARTRIDGE REPAIR GROUP

RPG05-113169

1/4-TURN CARTRIDGE (C) REPAIR GROUP

RPG05-113179

1/4-TURN CARTRIDGE (H) REPAIR GROUP

ITEM NO. PART NO. DESCRIPTION