Installation Guide

12
CONNECT TO
HOT WATER
SUPPLY LINE
(NOT INCLUDED)
CONNECT TO
COLD WATER
SUPPLY LINE
(NOT INCLUDED)
CONNECT TO
HAND SHOWER
HOSE
• Use 2 of the larger diameter hoses provided to make connections from the Endbody Outlets to the Diverter Inlets as shown. Hot to H, Cold to C.
• Use the remaining larger diameter hose provided to make a connection from the Lower Diverter Outlet to the Spout Inlet as shown.
• Connect the smaller diameter hose provided to the rear outlet of the Diverter as shown.
• Make Supply Line connections as shown. NOTE: Supply Line Hoses are not included.
• Wrench tighten all Hose connections. NOTE: Installer may slightly loosen the End Bodies and/or the Diverter Body in case of any difficulty in Wrench tightening of Hose connections.
• Repeat STEP 11 to ensure that the Flanges and Handles are properly aligned.
NOTE: Supply Lines are not included.
WATER SUPPLY CONNECTIONS
HOT
COLD
13
• Place the threaded end of the Hand Shower
Hose through the Mounting Collar.
• Install threaded end of Hand Shower Hose to the
Hose exiting from the rear port of the Diverter
Valve. Wrench Tighten.
HAND SHOWER HOSE INSTALLATION
14
Determine the desired extended length of Hand Shower Hose while in use. From below install the Clip to the
Hand Shower Hose so that it will make contact with the Sleeve when extended length is reached.
HAND SHOWER HOSE CLIP INSTALLATION