Installation Guide

6
❶ From above, insert the Hand Shower Support into Hole 5. Secure into position using the Rubber Washer,
Metal Washer, and Mounting Nut. Hand tighten the Mounting Nut into position. Do not wrench tighten at
this time.
❷ Install Sleeve onto Hand Shower Support and hand tighten into position.
HOLE
5
HAND SHOWER SUPPORT INSTALLATION
7
• Remove the pre-assembled Mounting Nut (1), Metal Washer (2), and Rubber Washer (3) from the Spout
Assembly .
• Insert the Spout Assembly from above through Hole 2.
• Reinstall the Rubber Washer, Metal Washer, and Mounting Nut. Hand tighten the Mounting Nut into position.
Do not wrench tighten at this time.
HOLE
2
SPOUT INSTALLATION
8
• With the Cartridge in the "Off" position, align Handle
to desired "Off" position, and engage the splines of the
Valve Cartridge into the Handle Assembly.
• Rotate Handle Flange until Set Screw is facing towards
rear of Tub Spout.
• Rotate the Handle from the "Off" position to the "On"
position and back again. Verify proper alignment of
Handle in the "Off" position.
HOT/COLD HANDLE INSTALLATION
SB-2531
HANDLE ALIGNMENT
SB-2533
HANDLE ALIGNMENT
9
• Position the Diverter Handle onto the Mounting Collar and engage the splines of the Diverter Cartridge into
the Handle Assembly. The Set Screw should be facing towards the rear of the Tub Spout.
DIVERTER HANDLE INSTALLATION
SB-2531
DIVERTER HANDLE ALIGNMENT
SB-2533
DIVERTER HANDLE ALIGNMENT
10
• Position Hand Shower Holder onto the Mounting Collar. The Set Screw should be facing towards the rear of
the Tub Spout.
HAND SHOWER FLANGE INSTALLATION
11
2.5mm
• From above, ensure the Flanges are aligned horizontally. Tighten all Set Screws to secure the Flanges into
position with included Hex Key Wrench. Wrench tighten Cold/Hot End Bodies, the Diverter Body, and the
Hand Shower Support from below using the Adjustable Wrench, while ensuring all Base Flanges remain
properly aligned.
CONFIRM PROPER ALIGNMENT