Installation Guide

6
From above, align Spout and Handle bases so that they are aligned horizontally.
7
While maintaining the proper alignment, Wrench Tighten Spout Mounting Nut (1). Then
snug Endbody Mounting Nuts (2). Final tightening of Endbody mounting is accomplished
by Tightening the Mounting Screws (3) while using a Phillips Screwdriver. Wrench tighten
Spout Inlet Hose (4).
8
From below, install the Endbody Outlet Hoses (1) (shorter hose) to the Inlet Tee of the Spout (2).
Wrench Tighten. Wrench tighten Spout Inlet Hose (3) to Inlet Tee (2)
9
Make connections to water supplies. The inlet threads of the faucet are 9/16”-24 UNEF and will
accept a 3/8” Compression Fitting. Wrench Tighten.
Accepts a 3/8”
Compression
Fitting
SUPPLY STOPS NOT INCLUDED
10
Remove Mounting Nut (1), Metal Washer
(2), and Sealing Washer (3) from Drain
Assembly.
11
Apply included Upper Drain Seal (1) or
Plumber’s Putty to the underside of the
Upper Flange. Insert Drain Assembly into
drain hole of sink from above.
12
From below, install Sealing Washer (3),
Metal Washer (2), and secure with
Mounting Nut (1). Tighten with Slip Joint
Pliers. Take care to not over-tighten
connection.
13
Test Drain operation by pressing down on
Stopper to open/close Drain.