Installation Guide

RPG04-0434 (-BN)
1
RPG05-0917
2
RPG45-0060
3
RPG05-0915 (1.5GPM)
4
Tighten lock nut (1) by rotating clockwise
until the pop-up drain assembly is secure.
Rubber washer should be on top of sink.
Place one end of spring clip (1) on the end of
pivot rod (2). Insert rod through hole in lift rod
strap (3).Secure with spring clip (1).
Insert lift rod (1) into strap (2) and tighten screw(3).
8
7
6 9
1
3
1
2
1
2
3
After installation is completed, remove aerator.
Turn on water supply and allow both hot and
cold water to run for at least one minute each to remove
the debris. While water is running ,check for leaks.
Replace aerator.
IMPORTANT:
20°
5.59”
[142mm]
5.51”
[140mm]
MAX 0.97”
[25mm]
4.02”
[102mm]
6.77”
[172mm]
4.84”
[123mm]
2.00”
[51mm]
1.69”
[43mm]
2
4
3
2X
1
5
RPG07-0135
5
RPG05-40126 (1.2GPM)
6
6