Installation Guide

INSTRUCTIONS FOR MODELS
92-CPV-SBC-01
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
[e-mail]
www.speakman.com
CPV-SBC
HELPFUL TOOLS & SUPPLIES:
TOOLS AND SUPPLIES
Adjustable
Wrench
Slip Joint
Wrench
Thread Seal
Tape
Safety
Glasses
Warranty information can be found at:
www.speakman.com
WARRANTY
Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.
MAINTENANCE
Cover your drain to prevent loss of parts. Be sure to
wear eye protection while cutting pipe.
SAFETY TIPS
IMPORTANT
• Be sure to read instructions thoroughly before
beginning installation.
• Do not over-tighten any connections or damage
may occur.
• This system has an operating range of 20-80 psi.
1
The “COLD” and “HOT” Endbody Assemblies are clearly marked. Remove Valve Support (1) and Rubber
Washer (2) from the Cold Side Endbody. Thread Endbody Mounting Nut (3) all the way down the Endbody.
Repeat this for the Hot Side Valve Body.
X2
2
• From below, insert COLD Endbody Assembly (1)
up through hole in counter top. From above, place
Rubber Washer (2) over Endbody Assembly (1).
Thread Valve Support (3) on to Endbody Assembly
and Hand Tighten into position.
• Align Endbody (1) so the Outlet is facing towards
the center as shown below. From below Hand
tighten Mounting Nut (4) into position.
• Repeat for HOT Endbody Assembly.
TO
CENTER
TO
CENTER
X2
3
Remove Top Nut (1) and Rubber Washer (2) from the Spout Assembly. Thread Endbody Mounting Nut (3) all
the way down the Endbody.
4
• From below, insert the Lower Spout Assembly (1)
up through hole in counter top. From above, place
Rubber Washer (2) over Assembly (1). Thread Top
Nut (3) on to Endbody Assembly and Hand Tighten
into position.
• Align Lower Spout Assembly so the Tee Inlets are
aligned to the Valve Endbody Outlets.
• From below, hand tighten Mounting Nut (4) while
maintaining alignment of Tee Inlets.
TO
HOT
TO
COLD
TO
HOT
TO
COLD
5
Install SB-3131 Lucid 3 Piece Bath Trim as per Instructions (not included).
While maintaining the proper alignment, wrench Tighten Spout Mounting Nut (1). Then Wrench Tighten
Mounting Nuts on the Valve Bodies (2).
6
From below, install the included Hoses between the Endbody outlets and the Inlet Tee of the Spout.
Wrench Tighten. Install Inlet Hoses (not provided) to the Valve Bodies. Wrench Tighten. Inlet connections are
½”-14 NPSM.
½”-14 NPSM
INLET SUPPLIES NOT INCLUDED