Installation Sheet

Place Handle Spacer (1) onto the Valve

(2). Ensure it is properly aligned as shown

below and seated onto the trim.

Confirm that the Valve is in the Vertical

position. Thread the Handle Adapter and

Retaining Collar (1) onto the Mounting

Base (2). Take care to align the Wall Plate

as shown below. Lock it into place. Hand

tighten until snug.

* VALVE IN VERTICAL POSITION

Ensure the Handle Adapter and Retaining Collar (1) are in a perfectly vertical position with the

Snap located at the bottom. Align the HEX Spindle (2) with the HEX drive (3) of the Handle

Assembly. Keep Handle in a stationary vertical position as you snap the Handle Hub (4) on to

the Mounting Base. Ensure the Snap is fully seated in the hole and that the Handle Spacer is

properly aligned and seated into the handle.

* VIEW FROM UNDER THE HANDLE ASSEMBLY.

MOUNTING BASE AND WALL PLATE NOT SHOWN.

* VIEW FROM UNDER

THE HANDLE ASSEMBLY.

SNAP AT BOTTOM

CPT-1124 ROUGH-IN DIAGRAM

SPEAKMAN

DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.

NOTES:

COMPLIANCE:

ASME A112.18.1/CSA B125.1

Contractor to supply necessary inlet

connections.