Installation Guide

3
Align the HEX Spindle (1) with the HEX drive (2) of the Handle Assembly. Keep Handle in a
stationary vertical position as you thread Handle Hub (3) on to Mounting Base. Verify proper
alignment of Wall Plate. Tighten until snug.
* VIEW FROM BACK OF HANDLE ASSEMBLY.
MOUNTING BASE AND WALL PLATE NOT SHOWN.
CPT-1110 ROUGH-IN DIAGRAM
SPEAKMAN
®
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
NOTES:
COMPLIANCE:
CONNECTIONS:
ASME A112.18.1/CSA B125.1
• Inlet: ½” NPT Female
• Outlets: ½“ NPT Female
Contractor to supply necessary inlet
connections.