Installation Guide

11
Remove Stopper ❶, Flange Nut ❷, and Flange
Washer ❸ from Drain Assembly.
12
From beneath, insert Drain Assembly through
drain hole in sink. Attach supplied Flange
Washer ❶ or plumber’s putty to the underside of
the Flange ❷. Secure Flange ❷ to the Drain
Assembly. Align the Drain Assembly as shown
below.
Align towards faucet.
13
From beneath, secure Rubber Washer ❶, Plastic
Washer ❷, and Mounting Nut ❸. Wrench
tighten.
14
Remove Pivot Nut ❶, from Drain Assembly.
Install Outer Pivot Washer ❷, and Pivot Rod ❸.
Ensure that Inner Pivot Washer ❹ is retained in
Drain Assembly. Insert Pivot Rod into Drain
Assembly and install Stopper ❺ as non-remov-
able. Secure Pivot Rod to Drain Assembly by
tightening Pivot Nut ❶.
15
Place one end of Spring Clip ❶, on Pivot Rod ❷. Insert Pivot Rod ❷ through a hole in the Lift Rod Strap ❸.
Secure with Spring Clip ❶.
16
Place Drain into the open position by pressing downward on the Pivot Rod ❶. Insert Lift Rod ❷ into Strap ❸.
Adjust height of Lift Rod ❷, and tighten Thumb Screw ❹.
17
Additional adjustments can be made to ensure a proper seal between the Drain Stopper ❶ and Drain
Assembly. Remove Pivot Nut ❷, from Drain Assembly. Slide out Pivot Rod Assembly ❸ . Remove Drain Stopper
❶. Additional adjustments can be made by either threading in or out the eyelet portion of the Drain Stopper ❶.
18
Turn on water supplies and flush both COLD and HOT cartridges for one minute, while checking
for leaks. Return Handles to closed position when complete.
19
Align threaded hole of Aerator towards the rear as shown above. Install Aerator and secure into
position using the included Hex Wrench.