Installation & Assembly

6
From above, align Spout and Handle bases so that they are aligned horizontally.
7
While maintaining the proper alignment, Wrench Tighten Spout Mounting Nut (1). Then
snug Endbody Mounting Nuts (2). Final tightening of Endbody mounting is accomplished
by Tightening the Mounting Screws (3) while using a Phillips Screwdriver. Wrench tighten
Spout Inlet Hose (4).
8
From below, install the Endbody Outlet Hoses (1) (shorter hose) to the Inlet Tee of the Spout (2).
Wrench Tighten. Wrench tighten Spout Inlet Hose (3) to Inlet Tee (2)
9
Make connections to water supplies. The inlet threads of the faucet are 9/16”-24 UNEF and will
accept a 3/8” Compression Fitting. Wrench Tighten.
Accepts a 3/8”
Compression
Fitting
SUPPLY STOPS NOT INCLUDED
10
Insert Lift Rod (1) down into the hole in the flange in the back of the Spout.
Orient Lift Rod as shown below.