Owner`s manual

A/V Receiver
SAT
DVD
PT-1.0
Passive Terminator
IRC-3.0
Shelf Top
IR Receiver
IRE-4.0 Dual
Visible Emitter
IRE-3.0
Visible Emitter
IRE-4.0 Dual
Visible Emitter
OPTIONAL LEAD - For a Basic System Using STATUS
Remote Control
IR RCVR
PT-1.0
12V DC
EMITTERS
STATUS
To 120 V AC
(unswitched)
PS-1.0
Power
Supply
PS-1.0
"STATUS"
Suppl
y
To Switched
AC Outlet on
A/V Receiver
12 V Lead
Top View
1-3/4" (44.5mm)
Side View
Peel-off Adhesive
Protective Cover
IR RCVR
PT-1.0
12V DC
EMITTERS
STATUS
1-1/16"
(27mm)
5/8"
(16mm)
PT-1.0 Passive Terminator
A Basic System
The PT-1.0 provides a quick and low cost means of interconnecting SpeakerCraft
Quad Mini-Plug equipped IR Receivers with other IR products in basic IR repeating
systems. It includes a STATUS jack. Current sharing resistors at each Emitter jack
allows any combination of single or dual emitters to be used.
1. Plug in the IR Receiver and Emitters as shown.
Note
1: If the IRC-3.0 lead is not long enough, you can
extend it’s length by using the SpeakerCraft Model QIX-1.0
Quad IR 15' Extension Cable (optional).
Note
2: Since the PT-1.0 employs emitter current sharing,
you may use any of the IRE-1.0 and 2.0, 3.0, or 4.0
SpeakerCraft emitters in any combination you wish.
2. Plug in the Power Supply.
3.
For A Basic System Using STATUS
To do this, you would simply plug a PS-1.0 Power Supply
into the switched AC Outlet on the rear of the A/V
receiver, as shown. The 12V lead of the PS-1.0 is then
plugged into the ST
ATUS jack on the PT-1.0. In this way,
the green status LED in the IR Receiver will go
ON and
OFF when the A/V receiver is turned ON and OFF. This
gives a power indication, for instance, when the
equipment is behind closed cabinet doors.
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,PT-1.0 • LINEAR P/N: 224726X1 • INK: BLACK • MATERIAL: 70 LB. GLOSS
WHITE COATED PAPER • SIZE: 4.250” X 5.500” FOLD TO 4.250” X 2.750” •
FOLDING: 1 FOLD HORIZONTAL, FINISH WITH LOGO SHOWING • SCALE: 1-1
224726X1 • IMAGE 2