Instruction Manual
Geometric Wall Sconces
Hubbell Outdoor Lighting • 701 Millennium Boulevard Greenville, SC 29607 • www.hubbelloutdoor.com • 864-678-1000
RTP – Radius Trapezoid QSP – Quarter Sphere RDI – Radius
TRP – Trapezoid
INSTALLATION INSTRUCTIONS
SAFETY PRECAUTION
INSTALLATION
Before starting the installation and servicing, disconnect the power by turning o the circuit breaker. Turning the power
o by using the light switch is not sucient to prevent electrical shock. All work should be done by a qualied electrician.
Direct mounting to recessed box (wall mounting)
1. Remove the mounting plate by unscrew 2 hex bolts from the xture.
2. Fastening the mounting plate to recessed outlet box while leveling the mounting plate by the level bubble to the
horizontal line.
3. Splice leads and push splices into outlet box.
4. Care should be taken when mounting xture not to pinch the wire leads. Align the xture against the mounting plate.
5. Secure the xture by tighten the 2 hex bolts to lock the mounting plate.
6. For wet locations, caulk between rear gasket and mounting surface to prevent water from entering the xture
from behind.
7. Install lamp of proper wattage and lamp type provided with xture.
CAUTION: Downward light is correct position. Upward light is incorrect position. This xture must be mounted in the cor-
rect position, otherwise it will cause unit failure.
NOTE: For RDI/RTP Up-Down xture, the smaller open frame is upward lighting, the big open frame is for downward
lighting. Never install xture in opposite position.
See the ballast wiring label and the rating label to locate the power tap to the appropriate voltage tap. If supplied with a
single voltage tap, make sure the voltage furnished to the xture is the same as specied on the unit.
CAUTION: Make sure all unused ballast taps are capped to avoid a short circuit to the reector when The xture is energized.
CAUTION: DISCONNECT ELECTRICAL CIRCUIT BEFORE REPLACING LAMP
o Check your power source o Check electrical connections o Check to insure proper seating of lamp o Check if lamp burned out
1. Release the screws and open the door frame.
2. Replace the correct lamp.
3. Close the door frame by tighten the screws.
SET BALLAST VOLTAGE
REPLACING LAMP
WARNING: This product contains chemicals know in the
state of California to cause cancer, birth defects and or other
reproductive harm. Thoroughly wash hands after installing,
handling, cleaning or otherwise touching this product.