User Manual

Hu bbell Lig ht ing, Inc. Do c. No . 93023606
A subsidia ry of Hu bbell Incorpor at ed Revision -
701 Mil lennium Dr ive • Greenville, SC 29607 Phone ( 86 4) 67 8- 1000
Outdoor Lighting
®
FIG UR E 1
V ANDAL
S HIELD
S PACER
INSTALLATION INSTRUCTIONS FOR LARAMIE LFL
EXTERNAL ACCESSORIES
PREPARING DOOR FOR TOP VISOR (LFL - TVBZ)
1. Open Door. Loosen (2) Door Screws and swing Door out (See Fig. 1).
2. Remove (2) Retaining Washers and Remove Door.
3. Remove (2) Screws and (2) Clips in middle of door that retain the Lens (See Fig. 2).
4. Drill (2) .172” diameter holes through door using the cored holes in the casting.
5. Turn door over and drill (2) .172 diameter holes through door using drill points (See Fig. 3 & 4 ).
6 . Replace (2) Screws and (2) Clips that retain the Lens.
7. Mount Visor (A) with (4) screws (B),
POLYCARBONATE VANDAL SHIELD (LFL - SPC)
1. The Vandal Shield Kit contains the following:
(4) Spacers
(4) Washers
(4) Screws
(1) Vandal Shield
2. Remove contact paper from Vandal Shield.
3. Mount Vandal shield to the Door with
Spacers, Washers, an d Screws as shown in Fig. 5.
(2) DR ILL PO IN TS FOR VISOR
AND FOR VANDAL S HI EL D.
D RILL THRO UGH DOOR.
(2) DR ILL PO IN TS
FOR VA N DAL S HI EL D.
D RILL THRU D OOR.
(2) CL IPS HOL DIN G L ENS
D RILL (2) .1 72" DI A. HOL E S
THRO UGH DOOR FOR VISOR.
VI SOR
A
SCREW S
B
DOOR
SCREW S
RET A INER
WAS H ER S
FIG UR E 2
FIG UR E 3
FIG UR E 4
FIG UR E 5
(2) CL IPS
HO L DIN G
LENS
DOOR
HIN GE
PREPARING DOOR FOR INTERNAL LOUVER (LFL - IL )
1. Open Door. Loosen (2) Door Screws and swing Door out (See Fig. 1).
2 . Remove (2) Screws and (2) Clips at end of door that retain the Lens .
(See Fig. 6 ).
3 . Place Internal Louver (C) on top of len s with Louver flange at end of Lens.
4 . Replace (2) Screws and (2) Clips to retain the Lens and the Internal Louver .
5 . Close Door and tighten Door Screws.
SCR EW
W AS HER
FIG UR E 6
LO UV ER
F LAN GE
C