Owner manual

1 . MOUNTING MAST ARM FITTER TO FIXTURE AND TO MAST ARM PIPE
Loosen (2 ) Screws and swing open Door .
Loosen (1) Reflector Panel Screw and swing open Reflector.
Attach Fixture with Gasket to Mast Arm Fitter with (2) ½” Hex Bolts, Lockwashers and Flatwashers .
Torque ½” Bolts to approx. 4 2 Ft - Lbs.
Engage (4) 3/8 - 16 X ¾” Set - screws to the cast Mast Arm Fitter.
Slip Arm Fitter onto Mast Arm and adjust Fixture orientation while tightening the (4) Set - screws.
After Leveling the Fixture attached to the Mast Arm, use holes on each side of Mast Arm Fitter to Field Drill
13/32” dia. hole through the Mast Arm Pipe .
Remove Arm Fitter and Fixture from Mast Arm Pipe and Pull the supply wires from Mast Arm Pipe
through Mast Arm Fitter and into the Fixture .
Slip Mast Arm F itter with Fixture back onto the Mast Arm Pipe, Install the 4 ” long Bolt and tighten the
(4) Set - screws to approx 18 Ft - Lbs.
Secure 4 ” Bolt with Flatwasher, Lockwasher, and Nut (Hardware Included). Torque the Bolt and Nut to
approx. 20 Ft - Lbs.
WARNING : FAILURE TO INSTALL THE LONG BOLT COULD POSSIBLY ALLOW THE FIXTURE TO
ROTATE OR DISENGAGE FROM THE PIPE ARM.
OR MA I NTENAN CE
WARNING:
D ISCON NECT P OW ER B EF ORE I NST AL LATION
AF TE R LEV ELI N G FI XTUR E T H AT
IS ATT ACHED TO MA ST A RM PIPE,
US E H OLE I N MA ST A RM FITT ER TO
FI EL D DR ILL H OLE T HROUGH PIPE.
M AS T AR M FITT ER
CIM AR RON FIX TURE
GASKE T
FLAT WA SHER
1/2" HE X B OLT
LOCK WA SHER
2
.
WIRING
POWER MUST BE OFF.
(WIRING MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN)
Wire service leads to fixture power leads according to local and National Electric Codes.
This Luminaire is equipped with HID Ballasts capab le of 120V - 480 V input .
Wire conn ections to be made inside Fix ture and Supply Wires to be secured inside Fixture.
For direct wire connections, connect ground wire to green wire, c onnect black to black and
white to neutral . Supply Voltage must match Ballast Voltage.
Close Reflector and s ecure with S crew. Close Door and tighten (2) Door Screws.
See Installation Instructions for Cimarron , P/N 268 - 1300 - 9901.
M AS T AR M PIPE
3/8" SET -SCREWS
4" LO N G BOL T
SAVE THESE INSTRUCTIONS
CIMARRON CR1 MAF INSTALLATION INSTRUCTIONS
DOOR
F LAT W AS HER , LO CKW AS HER , NUT
701 M il l ennium Boul eva rd Gre en v il le , S C 29607 (8 6 4) 67 8- 1000
www. spau lding-ltg. co m
9303863 1 REV A