Operation Manual
Original instructions EN
5
This will ensure that the safety of the power
tool is maintained.
IV - Additional safety rules
for angle drills / drivers
-
forming an operation where the driving screws may
contact hidden wiring. Contact with a “live” wire will
make exposed metal parts of the tool “live” and shock
the operator.
-
tion, because it does not have to be plugged into an
electrical outlet. Always set the trigger switch to the
battery pack.
V - Additional instructions
for work with the charger
cautionary markings on the charger and battery pack
as well as the instructions on using the battery pack.
designed for indoor use only.
WaRning: If the battery pack is cracked
or damaged in any other way, do not insert it in the
charger. There is a danger of electric shock.
WaRning: Do not allow any liquid to come
into contact with the charger. There is a danger of
electric shock.
charging the exact type of SPARKY rechargeable
battery pack as supplied with the charger. Any other
use may result in the risk of fire or electric shock.
specifically designed to work together. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
could cause overheating. Do not place the charger
near any heat source.
from the power source.
it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
necessary. The use of an improper extension cord
could cause the risk of fire or electric shock.
heavy knock, dropped or otherwise damaged in any
way. Do not operate charger with damaged cord or
plug - have them replaced immediately. Take the
charger to an authorised service centre for a check or
repair.
-
ised service centre when service or repair is required.
Incorrect re-assembly may result in the risk of fire or
electric shock.
charger from the power supply before attempting to
clean it. Removing the battery pack alone does not
reduce the risk.
-
tempt to connect the charger to a supply with a differ-
ent voltage.
the charger from the mains supply and leave it for at
least 15 minutes. After this time you can charge a sec-
ond battery pack.
to the power supply, the exposed charging contacts
inside the charger can be shorted by foreign material.
not limited to, steel wool, aluminium foil, or any build-
up of metallic particles should be kept away from
charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cav-
ity. Unplug charger before attempting to clean.
other liquid.
VI - Additional instructions
for work with the
battery pack
low charge condition. You should charge the battery
pack fully before use.
if the battery pack is charged when the air tempera-
-
tant and will prevent serious damage to the battery
set.
touch while charging. This is a normal condition, and
does not indicate a problem.
in direct sunlight in hot weather or near heat sources.
The battery must be placed in a well ventilated area
during charging.
may occur under extreme usage or temperature con-
the outer seal is broken and this leakage gets on your
skin:
- Wash quickly with soap and water.
- Neutralise with a mild acid such as lemon juice or
vinegar.