Users Manual

Wireless
Module
KDB 996369 D03 OEM Manual v01 rule sections:
2.2 List of applicable FCC rules
This module has been tested for compliance to FCC Part 15.
2.3 Summarize the specific operational use conditions
The module is tested for standalone mobile RF exposure use condition. Any other usage
conditions such as co-location with other transmitter(s) or being used in a portable condition
will need a separate reassessment through a class II permissive change application or new
certification.
2.4 Limited module
procedures Not
applicable.
2.5 Trace antenna
designs Not
applicable.
2.6 RF exposure considerations
This equipment complies with FCC mobile radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator & your body. If the module is installed in a
portable host, a separate SAR evaluation is required to confirm compliance with relevant
FCC portable RF exposure rules.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type with
equal or lower gain may also be used with this module. The antenna must be installed such that 20 cm
can be maintained between the antenna (refer to Page 9, Antenna Approved List) and users.
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID:
RYK- WPEQ262ACNIBT. The grantee's FCC ID can be used only when all FCC
compliance requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located
or simultaneous transmission with other transmitter(s) or portable use will require a
separate class II permissive change re-evaluation or new certification.
Antenna Type Dipole/ PIFA
Antenna connector RP-SMA