User Manual

11
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec un minimum de 20cm de distance entre la source de rayonnement et votre
corps
Modular OEM Integrator Notice
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de dispositif
module)
1) L'antenne doit être installée de telle sorte qu'une distance de 20cm est respectée entre l'antenne et les utilisateurs, et
2) Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install module
2. the ISED compliance requirement of the end product, which integrates this module.
3. Appropriate measurements and if applicable additional equipment authorizations of the host device to be addressed
by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including portable configurations and different
antenna configurations
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains transmitter module IC:
6158A-WPEA352ACNB”.
Contient le module d'émission IC: 6158A-WPEA352ACNB
The Host Model Number (HMN) must be indicated at any location on the exterior of the end product or product packaging
or product literature which shall be available with the end product or online.