Users Manual

ManualsBrandsSparkLAN ManualsElectronics802.11ac/b/g/n WiFi + Bluetooth M.2 Module

Wireless Module

WNFQ-262ACNI(BT)

Standards

IEEE 802.11ac/a/b/g/n (2T2R)

Bluetooth V5.0,V4.2,V4.1, V4.0 LE, V3.0+HS, V2.1+EDR

Chipset

Qualcomm Atheros QCA6174A-5

Data Rate

802.11b: 11Mbps / 802.11a/g: 54Mbps / 802.11n: MCS0~15/ 802.11ac: MCS0~9

Bluetooth: 1Mbps, 2Mbps and up to 3Mbps EDR

Operating Frequency

IEEE 802.11 ac/a/b/g/n ISM Band, 2400MHz~2483.5MHz, 5.150MHz~5.850MHz

*Subject to local regulations

Interface

PCIe: WLAN; USB: Bluetooth

Form Factor

M.2 2242 B key

Antenna

2xIPEX connector

Ant 1 for WLAN

Ant 2 for WLAN/BT

Modulation

802.11b: DSSS (GFSK, DBPSK, DQPSK, CCK)

802.11a/g: OFDM (GFSK, BPSK, QPSK, 16-QAM, 64-QAM)

802.11n: OFDM (GFSK, BPSK, QPSK, 16-QAM, 64-QAM)

802.11ac: OFDM (GFSK, BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM)

Power Consumption(Max.)

TX: 610mA

RX: 298mA

Operating Voltage

DC 3.3V

Operating Temperature Range

-40°C~85°C

Storage Temperature Range

-45°C~90°C

Humidity

(Non-Condensing)

5%~90% (Operating)

5%~90% (Storing)

Summary of content (11 pages)

PAGE 1
Wireless Module WNFQ-262ACNI(BT) IEEE 802.11ac/a/b/g/n (2T2R) Standards Bluetooth V5.0,V4.2,V4.1, V4.0 LE, V3.0+HS, V2.1+EDR Chipset Qualcomm Atheros QCA6174A-5 802.11b: 11Mbps / 802.11a/g: 54Mbps / 802.11n: MCS0~15/ 802.11ac: MCS0~9 Data Rate Bluetooth: 1Mbps, 2Mbps and up to 3Mbps EDR IEEE 802.11 ac/a/b/g/n ISM Band, 2400MHz~2483.5MHz, 5.150MHz~5.850MHz Operating Frequency *Subject to local regulations Interface PCIe: WLAN; USB: Bluetooth Form Factor M.
PAGE 2
Wireless Module Dimension (in mm) 22mm x 42mm x2.78mm (±0.5mm) Weight (g) ≦ 6g Windows 7/8.1/10 Driver Support Linux (Open Source), Recommend Kernel v4.0+ Security 64/128-bits WEP, WPA, WPA2, 802.
PAGE 3
Wireless Module Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 4
Wireless Module Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the following conditions must be strictly followed when using this certified module: KDB 996369 D03 OEM Manual v01 rule sections: 2.
PAGE 5
Wireless Module 2.8 Label and compliance information The final end product must be labeled in a visible area with the following: “Contains FCC ID: RYKWNFQ262ACNIBT. The grantee's FCC ID can be used only when all FCC compliance requirements are met. 2.
PAGE 6
Wireless Module transmitter module for compliance with the Radio and EMF essential requirements of the FCC rules.
PAGE 7
Wireless Module Industry Canada statement: This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.
PAGE 8
Wireless Module 3) Approbation du Module valable que lorsque le module est installé dans l'hôte testé ou de la série de l'hôte compatible qui ont même caractéristique de l'exposition aux RF avec la distance égale ou supérieure séparation antenne. Tant que les 3 conditions ci-dessus sont remplies, des essais supplémentaires sur l'émetteur ne seront pas nécessaires.
PAGE 9
Wireless Module Manuel d'information à l'utilisateur final L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel.
PAGE 10
Wireless Module not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Le présent émetteur radio (IC: 6158A-FQ262ACNIBT / Model: WNFQ-262ACNI(BT)) a été approuvé par ISED pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal.
PAGE 11
Wireless Module Approved antenna(s) list No. 1 2 3 4 5 Transmitte r Circuit Chain(0) Chain(1) Chain(0) Chain(1) Chain(0) Chain(1) Chain(0) Chain(1) Chain(0) Chain(1) Brand Model Antenn a Type 2.4G gain (dBi) 5G gain (dBi) Connector Type Sparklan AD-305N Dipole 5 5.53 RP-SMA Sparklan AD-300N Dipole 3 5 RP-SMA Sparklan AD-103AG Dipole 2.02 2.