User Manual
Table Of Contents
- Copyright Statement
- Federal Communication Commission Interference Statement
- 1.1 Advantages of VoIP to Businesses
- 1.2 SIP – Most Popular VoIP Protocol
- 1.3 VoIP-Friendly Networking Concepts
- 2.1 Operation Modes
- 2.2 Wireless Modes
- 2.3 Topologies of Network Application
- 3.1 Overview of WIFI-ATA
- 3.2 Key Features of WIFI-ATA
- 3.3 Outlook of WIFI-ATA
- 3.4 Web Configuration Environment
- 4.1 Quickly Setup (Setup Wizard)
- 4.2 Operation Mode
- 4.3 TCP/IP Settings
- 4.4 VoIP Settings
- 4.5 Wireless settings
- 4.6 Firewall settings
- 4.7 Management
- 5.1 How can I make a phone call?
- 5.2 How can I pick up the call waiting while I’m on the phon
- 5.3 How can I make a 3-way conference call?
- 5.4 How can I transfer a call to others?
- 5.5 Why can’t I login to the WIFI-ATA?
- 5.6 Why can’t I access the Internet?
- 5.7 Why can’t I make VoIP phone calls to others?
- 5.8 WIFI-ATA doesn’t respond correctly to key press sometime
Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise
without the prior writing of the publisher.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country
dependent and are firmware programmed at the factory to match the intended destination. The
firmware setting is not accessible by the end user.