User's Manual

802.11g USB 2.0 WLAN

Module User Manual

Chapter 5. How to use the WLAN Utility(Access Point)

5.1 Introduction

To set your 802.11g USB 2.0 WLAN

Module as an Access Point(AP) , reference

In Access Point mode , your 802.11g USB 2.0 WLAN

Module as an AP . this allows you to

set up your wireless network without using a dedicate AP device. Up to 16 wireless station

can associate to 802.11g USB 2.0 WLAN

Module.

5.1.1 Additional Setup Requirement

To bridge wireless and wired using the 802.11g USB 2.0 WLAN

Module, The following

requirement must be met.

1. The 802.11g USB 2.0WLAN

Module must be installed a computer connect to the wired

network.

2. Either configure network sharing or bridge the two interfaces(Wireless & Wired) on the

computer.

3. Set the wireless station’s IP address to be in the same subnet as the computer in which

802.11g WLAN

module is installed.

5.2 The 802.11g WLAN

module Utility Screen

5.2.1 Select “ACCESS POINT” in the MODE field to display the screen as shown.

ACCESS POINT Mode

5.2.2 click “More Setting…”in the 802.11g USB 2.0 WLAN Module screen to display the

screen as shown.

Module