User's Manual

802.11g USB 2.0 WLAN
Module User Manual
14
Figure 4-2
4.3.2 Encryption Setting:
4.3.2.1 WEP Encryption Key Setting
Press “WEP Encryption Key Setting” to enter the “WEP Key Setting” page shown as
Figure 4-3-1.
- Press the “Change” button to modify the contents of “WEP Key setting”, when it is
finished, press “Apply” to save it. The button “Change” and “Apply” is alternately shown
on the same position.
- Select which key length 64,128 or 256 bits will be modified or used by “Key Length” item.
- Select which key set will be use by the field of “Default Key ID”
- Modify the 4 sets key depending on the selected key length on the field of “Key Value”.
The key value is used the hexadecimal format.
4.3.2.2 WPA Encryption Setting
Press “WPA Encryption Setting” to enter the “WPA Setting” page shown as Figure 4-3-2.
- Press the “Change” button to modify the contents of “WPA setting”, when it is finished,
press “Apply” to save it. The button “Change” and “Apply” is alternately shown on the
same position.
- Select from the Protocol drop-down menu for the Protocol setting: TLS, PEAP, TTLS
- Setting “User Name”, “Password”, and “Phase2 Auth” drop-down menu per Protocol
setting.
- Pre-shared key setting: “Passphrase”, and “Key Format” select (ASCII or Hexadecimal)
- “Certificate” selection per Protocol setting.