User's Manual

DRT-MAN-093
57/74
3.5 Operating the detector
3.5.1 Genral Workflow
The following workflow indicates the procedures for acquiring a clinical image after startup of EConsole1 and
other system equipments
· Preparing to use the detector
· Operating the detector
Attach a fully-charged battery pack to the detector.
2. Register
1)
the detector and make connection
2)
to the
EConsole1 power supply to the detector
1)
: A procedure in order to register the detector
to a specific digital radiography system
2)
: Network connection between the EVS 3643W
wireless detector and the Ecali
3. Conduct Examination
3)
:
ㆍ Selection of EVS 3643W wireless
from the Exprimer series detector
ㆍ Selection of wireless/wired data transfer
ㆍSelect or register the patient information
ㆍSelect the protocol (selection
3)
of the detector)
- Arrange the patient in the correct posture
- Position the X-ray generator to adjust the
exposure field
- Check all the conditions
Check the captured images
ㆍList the images
ㆍTransmit the images
Sterilize the portion of the detector that
has been in contact with a patient
· Ending use of the detector
1. Turn off the detector
ㆍConduct the next examination
Loop back procedure
for each body part
Loop back procedure
for each patient
For details, refer to the operation manual
or setup guide of the Ecali
2. Remove the battery pack
1. Turn on the detector
Figure 8. EVS 4343W(G) /3643W(G) General Workflow