User's Manual

DRT-MAN-093
41/74
 To reduce the risk of electric shock, the system must be connected to an electrical ground.
 A three-phase AC power cable is supplied with this system to provide the proper electrical grounding.
The power cable must be plugged into an UL-approved three-contact electrical outlet.
 Do not disassemble or modify the product as it may result in fire or an electric shock. There are no
operator serviceable parts or adjustments inside the system. Only a trained and qualified person
should be permitted access to the internal parts of the system.
 If an APPLIANCE COUPLER or Mains Plug or other separable plug is used, functional isolation
device should be used for safety.
Disinfection and cleaning
 Wipe it with a dry cloth slightly damped with a neutral detergent.
 Do not use solvents such as alcohol, thinner or benzene. Doing so may damage the surface of the
equipment.
 The power should be switched off and equipment should be unplugged before cleaning.
 The exterior of the array can be cleaned with common hospital decontamination solutions including 5%
of ButylCellosolve. A 0.55% Benzalkonium Chloride, 0.63% Sodium Hypochlorite, or 70% alcohol
solution can also be used. To apply the cleaning solution, power down the system and disconnect
from the power source, moisten cloth with the solution, and wipe the panel.
Operating/storage environment
 Be sure to use and store the equipment under the conditions described below.
Operation
Storage
Transit
Temperature
10 to 35℃
-15 to 55℃
-15 to 55℃
Humidity
20 to 85% RH
(Without Condensing)
10 to 90% RH
(Without Condensing)
10 to 90% RH
(Without Condensing)
Atmospheric pressure
700 to 1060 hPa
500 to 1060 hPa
500 to 1060 hPa
 Do not expose the equipment to high temperatures and/or high humidity. This may cause the product
to mulfunction.
 When not in use, keep the detector, handle unit, and grid in a designated location or in a location
where they are safe and cannot fall down.
Notes on disposal
 Disposal of this product in an unlawful manner may have a negative impact on health and on the
environment. When disposing of this product, therefore, be absolutely sure to follow the procedure
which is in conformity with the laws and regulations applicable in your area.
 Refer to lifetime dose at "2.1 Reliability (Lifetime Dose)".
Handling the equipment
 The equipment must be handled with care to avoid personal injury or damage to the internal image
sensor.