Manualshelf

User's Manual

ManualsBrandsSparkLAN Communications ManualsElectronics802.11abgn USB Module
31323334353637383940
DRT-MAN-093
40/74
3. Operating Procedure
3.1 Notes for using the equipment
When using the equipment, take the following precautions. Otherwise, problems may occur and the equipment
may not function properly.
EVS 4343WP /
System Diagnostic
The Ecali1 software generates a system diagnostic. Run Ecali1 software after installing the system and
execute the program at least once a year. If an error occurs, report the detailed error information to DRTECH
local dealer or distributor.
CAUTION
MISE EN GARDE
The owner is responsible for ensuring that the system diagnostic is performed at least
once a year. Do not try to use the system if an error is detected.
Il incombe au propriétaire de s'assurer que la vérification du système est effectuée
chaque année.
N'essayez pas d'utiliser le système si la vérification du système est négative.
Calibration
To ensure optimal performance of the system, it is important to verify that the system is calibrated.
CAUTION
MISE EN GARDE
The owner is responsible for ensuring that the system calibration is performed after
the system installation is completed or the system is repaired. Do not try to use the
system if system calibration is not performed.
Il incombe au propriétaire de s'assurer que l'étalonnage du système est effectué une
fois l'installation du système terminée ou la réparation du système. N'essayez pas
d'utiliser le système si l'étalonnage du système n'est pas effectué.
Before exposure
Make sure to check the equipment daily and confirm that it works properly.
When moisture-laden air comes into contact with a cold surface, it will cause condensation to form
on the equipment. In this case, wait until the condensation evaporates before performing an
exposure.
If the equipment is used while the condensation formed on it, problems may occur in the quality of
the captured image.
When an air-conditioner is used, be sure to raise/lower the temperature gradually so that
temperature changes will not affect the product and prevent condensation prevent condensation.
During exposure
Do not use the detector nearby devices generating a strong magnetic field. Doing so may produce
image noise or artifacts.
Electric Shock Hazards