User Manual

User’s Guide
6
3. Hardware Installation
Front Panel
The front panel provides LED’s for device status. Refer to the following table for the meaning of each feature.
Power
The Power LED lights up and will keep while the Router is powered on. When the
Router goes through
its self-diagnostic mode during every boot-up, this LED will flash. When
the diagnostic is complete, the
LED will be lit continuously.
DMZ
The DMZ LED indicates when the DMZ function is being used. This LED will remain lit
as long as DMZ
is enabled.
WAN The WAN LED lights up when there is a connection built through the Internet port.
WLAN The WLAN LED flashes when there is a successful Wireless connection.
Ethernet
LED 1, 2, 3, 4. These numbered LEDs, corresponding with the numbered ports on the Router’s rear
panel. If the LED is continuously lit, the Router is successfully connected to a device through that port.
A flashing LED indicates network activity over that port.