User's Manual

User’s Manual

want remove all Special Appliacation settings from the table, just click "Delete All" button.

Click "Reset" will clear your current selections.

Delete Selected:

Please select a special application by clicking the ‘Select’ box of the mapping, then click

‘Delete Selected’ button to remove the setting. If there’s no setting here, this button will be

grayed out.

Delete All:

Delete all settings existed in trigger port table.

Reset:

Unselect all settings.

Note: Only one LAN client can use a particular special application at a time.

After you finish with all settings, please click ‘Apply’ button and the following message will

be displayed on your web browser:

Please click ‘Continue’ to back to previous setup menu; to continue on other setup

procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please wait

for about 30 seconds while the router is rebooting).

If you want to reset all settings in this page back to previously-saved value, please click

‘Cancel’ button.

 UPnP Setting

This function enables network auto-configuration for peer-to-peer communications, with this

function, network devices will be able to communicate with other devices directly, and learn

about information about other devices. Many network device and applications rely on UPnP

function nowadays.

Please click ‘NAT’ menu on the left of web management interface, then click ‘UPnP’, and

the following message will be displayed on your web browser: