User's Manual

User’s Manual
53
Reset:
You can also click ‘Reset’ button to unselect all MAC addresses.
Enable Wireless Access Control:
To enforce MAC address filtering, you have to check ‘Enable Wireless Access Control’.
When this item is unchecked, wireless router will not enforce MAC address filtering of
wireless clients.
MAC Address:
Input the MAC address of your wireless devices here, dash ( - ) or colon ( : ) are not
required. (i.e. If the MAC address label of your wireless device indicates ‘aa-bb-cc-dd-ee-ff’
or ‘aa:bb:cc:dd:ee:ff’, just input ‘aabbccddeeff’.
Comment:
You can input any text here as the comment of this MAC address, like ‘ROOM 2A
Computer’ or anything. You can input up to 16 alphanumerical characters here. This is
optional and you can leave it blank, however, it’s recommended to use this field to write a
comment for every MAC addresses as a memory aid.
Add:
Click ‘Add’ button to add the MAC address and associated comment to the MAC address
filtering table.
Clear:
Click ‘Clear’ to remove the value you inputted in MAC address and comment field.
After you finish with all settings, please click ‘Apply’ button and the following message will
be displayed on your web browser:
Please click ‘Continue’ to back to previous setup menu; to continue on other setup
procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please wait
for about 30 seconds while router is rebooting).
If you want to reset all settings in this page back to previously-saved value, please click
‘Cancel’ button.