User's Manual

User’s Manual

Please select a proper operation mode you want to use from ‘Mode’ dropdown menu (1),

and continue on other operation mode specific settings:

 Setup procedure for ‘AP’:

Please select the radio band you want to use from ‘Band’ dropdown menu (2), and the

following message will be displayed:

Band:

Please select the radio band from one of following options:

1. 2.4 GHz (B): 2.4GHz band, only allows 802.11b wireless network client to

connect this router (maximum transfer rate 11Mbps).

2. 2.4 GHz (N): 2.4GHz band, only allows 802.11n wireless network client to

connect this router (maximum transfer rate 150Mbps).

3. 2.4 GHz (B+G): 2.4GHz band, only allows 802.11b and 802.11g wireless

network client to connect this router (maximum transfer rate 11Mbps for 802.11b

clients, and maximum 54Mbps for 802.11g clients).

4. 2.4 GHz (G): 2.4GHz band, only allows 802.11g wireless network client to

connect this router (maximum transfer rate 54Mbps).

5. 2.4 GHz (B+G+N): 2.4GHz band, allows 802.11b, 802.11g, and 802.11n

wireless network client to connect this router (maximum transfer rate 11Mbps for

802.11b clients, maximum 54Mbps for 802.11g clients, and maximum 150Mbps for

802.11n clients).

NOTE: For 802.11b and 802.11g mode, the signals can be transmitted only by

antenna 1 (The antenna in the right side of the rear panel).

For 802.11n mode: The router is operating in a 1T2R Spatial Multiplexing MIMO

configuration. 1 antenna is for signal transmitting and 2 antennas are for signal

receiving.